Led canbus anti flicker error free

Оригинальное название:

2X LED Headlight Canbus Error Free Anti Flicker Resistor Canceller Decoder H13

Покупки без ограничений

• Доставка в любой город СНГ
• Простой процесс оплаты
• Каталог на русском языке

Доступ к 3 млн. товаров

• Доставка в любой город СНГ
• Простой процесс оплаты
• Каталог на русском языке

Консолидация и сервис

• Доставка в любой город СНГ
• Простой процесс оплаты
• Каталог на русском языке

Косметика M.A.C.maccosmetics.com

Часы Timexamazon.com

Джинсы levi’sebay.com

So, i got these to help fix the flicker and error code my recently purchased led bulbs were causing on my 2017 Mini Clubman S. After i installed them, i noticed the flicker was much less, but still there. Then, once the car was switched on, the high beam error code reappeared.
The manufacturer of my bulbs sent me a message through Amazon that their bulbs worked in 99% of the vehicles without an issue, but, if i did experience flickering or error codes, simply reply to the email, and they would send me the canbus harness at no charge. I did just that.

Think about this: the system in your vehicle is looking for a certain amount of resistance in your bulbs. If it doesn’t see it, it throws an error code. Each bulb across different manufacturers will likely have different resistance values on their bulbs. They make the canbus adapter to compensate for this difference between their bulb and what the vehicle is looking for. If you mix manufacturers devices, your resistance can still be off, either too much or not enough, still causing error codes or flickering.

Lesson learned: if you need the canbus adapters for your vehicle, get them from the same manufacturer as your bulbs. It will probably work correctly.

I have a Chrysler 200S and I recently upgrade my headlights to LED. They worked for about a week straight error free. Suddenly out of no where I received the lightbulb out error. I got out and checked the light and it was working fine. Didn’t think anything of it until one day driving at night the error light came on and the bulbs shut off completely. Luckily there was still a light bit of light outside. I read that something about the wattage of LEDs were different than halogens and I would need this Canbus. Simple install that took about 5 minutes. Drove around with the lights on for about 15 minutes. No error and the lights did not cut off. My bulbs are 9012 and this was a life saver.

works great until its cold outside, once its cold outside they do not want to work at all.

These things did the trick for my 2014 Jeep Cherokee. The LED headlights would stay on for a minutes or so before turning off before I installed these. Be sure to test it before installing it. You can connect these 2 ways and they only work 1 way and are not labeled + -. I used a different brand of LED headlights with these.

I still get the dashboard error light with the led bulbs. I gave them 4 stars because their customer service was outstanding. It was the best I’ve experienced on Amazon.

When I went to instal product I thought I was the stupid one putting it on wrong and not matching the terminals together..but turns out they’re backwards..kinda strange but they work. The socket for where the female end meets the male end to the lights was too deep *on the decoder end* so I have to cut the end of it by 1/4 inch. But product does as listed.

Works as described, no issues installing.

Work as described, but polarity does not match up with plug on light. Had to have negative to the positive side of the LED bulb. Used electrical tape to secure connection.
After a few days, I get a «headlight off» message on dash.